AS 3572.3:2002
$15.60
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of loss on ignition of glass filament reinforced plastics
| Published By | Publication Date | Number of Pages |
| AS | 2002-02-08 | 4 |
This Standard sets out a method for determining the percentage by mass of resin in glass
filament reinforced plastics.
NOTES:
1 Where reinforced plastics contain organic fillers, or if the resin is incompletely combustible, the percentage by mass resin content cannot be determined directly by this method.
2 Glass content may be calculated directly provided no inorganic fillers are present.
Related products
-
AS 3523.3:2000 (R2013)
Identification cards – Identification of issuers – Australian national numbering system and registration procedures Publishedā¦
-
IEEE 1512.3 2006
IEEE Standard for Hazardous Material Incident Management Message Sets for Use by Emergency Management Centersā¦
-
ISO 3523:2002
Oil of cananga (Cananga odorata (Lam.) Hook. f. et Thomson, forma macrophylla) Published By Publicationā¦
-
AS 3572.5:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of hoopā¦
-
AS 3533.3:2003 (R2013)
Amusement rides and devices – In-service inspection Published By Publication Date Number of Pages ASā¦
-
AS 3572.10:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of theā¦
-
ACI 350.3 06 2006
350.3-06 Seismic Design of Liquid-Containing Concrete Structures and Commentary Published By Publication Date Number ofā¦
-
AS 2582.3:2003 (R2020)
Complete, filled transport packages – Methods of test – Stacking tests using a static loadā¦
-
AS/NZS 4357.3:2006
Structural laminated veneer lumber (LVL) – Determination of structural properties – Evaluation methods Published Byā¦
-
AS ISO 3452.3:2020
Non-destructive testing – Penetrant testing – Reference test blocks Published By Publication Date Number ofā¦
-
AS 3582.2:2001
Supplementary cementitious materials for use with portland and blended cement – Slag – Ground granulatedā¦
-
AS 3572.1:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Preparation of glassā¦
-
AS 3572.15:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of resistanceā¦
-
AS 1562.3:2006 (R2018)
Design and installation of sheet roof and wall cladding – Plastic Published By Publication Dateā¦
-
AS 3572.2:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of chemicalā¦
-
AS 3572.6:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of hoopā¦
-
IEEE 1512.3-2002
IEEE Standard for Hazardous Material Incident Management Message Sets for Use by Emergency Management Centersā¦
-
AS 3571.2:2009
Plastics piping systems – Glass-reinforced thermoplastics (GRP) systems based on unsaturated polyester (UP) resin –ā¦
-
AS/NZS 3582.3:2002
Supplementary cementitious materials for use with portland and blended cement – Amorphous silica Published Byā¦
-
AS 3572.9:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of pressureā¦
-
AS 3522.6:2002
Identification cards – Recording technique – Magnetic stripe – High coercivity Published By Publication Dateā¦
-
AS/NZS 3500.3:2003
Plumbing and drainage – Stormwater drainage Published By Publication Date Number of Pages AS 2003-12-15ā¦
-
AS 3571.1:2009
Plastics piping systems – Glass-reinforced thermoplastics (GRP) systems based on unsaturated polyester (UP) resin –ā¦
-
IEEE 1512.3 2002
IEEE Standard for Hazardous Material Incident Management Message Sets for Use by Emergency Management Centersā¦
-
AS/NZS 3750.3:2008 (R2020)
Paints for steel structures – Heat resisting – Exterior Published By Publication Date Number ofā¦
-
AS 3572.14:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of long-termā¦
-
AS/NZS 3584.3:2012
Diesel engine systems for underground coal mines – Maintenance Published By Publication Date Number ofā¦
-
AS 3572.0:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Introduction and listā¦
-
IEEE 1512.3-2006
IEEE Standard for Hazardous Material Incident Management Message Sets for Use by Emergency Management Centersā¦
-
AS 3572.12:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of initialā¦
-
AS 3572.8:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of longā¦
-
AS 3572.16:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Testing of flexibleā¦
-
IEEE 3527.1-2020
IEEE Standard for Digital Intelligence (DQ)–Framework for Digital Literacy, Skills, and Readiness Published By Publicationā¦
-
AS 3572.11:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of theā¦
-
AS 3582.4:2022
Supplementary cementitious materials Pozzolans ā Manufactured Published By Publication Date Number of Pages AS 2022-02-11ā¦
-
ACI 350.3 2020
ACI CODE-350.3-20: Code Requirements for Seismic Analysis and Design of Liquid-Containing Concrete Structures (ACI 350.3-20)ā¦
-
AS 3572.7:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of extensionā¦
-
ASTM-D5723 2002
D5723-95(2002) Standard Practice for Determination of Chromium Treatment Weight on Metal Substrates by X-Ray Fluorescenceā¦
-
AS 3572.4:2002 (R2016)
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of theā¦
-
AS 3572.13:2002
Plastics – Glass filament reinforced plastics (GRP) – Methods of test – Determination of theā¦