BSI 20/30409788 DC 2020
$13.70
BS IEC 60800. Heating cables with a rated voltage of 300/500 V for comfort heating and prevention of ice formation
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 31 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | UPI-NC |
| 3 | 20_1899e_CD |
| 9 | 1 Scope and object 2 Normative references |
| 11 | 3 Terms and definitions |
| 13 | 4 Mechanical classification 5 Requirement for marking |
| 14 | 6 Requirements for installation instructions |
| 15 | 7 General requirements for construction of cables 7.1 General 7.2 Conductors 7.3 Insulation 7.4 Electrically conducting screen |
| 16 | 7.5 Armouring 7.6 Sheath 7.7 Moisture resistance 8 Testing 8.1 Type tests – General requirements |
| 17 | 8.2 Type tests – Detailed test requirements 8.2.1 Electrical resistance of heating conductors and screen 8.2.2 Water immersion and temperature cycling test 8.2.2.1 General remark |
| 18 | 8.2.2.2 Dielectric test 8.2.2.3 Electrical insulation resistance test |
| 19 | 8.2.3 Verification of rated output for parallel heating cables 8.2.4 Verification of start-up current for parallel heating cables 8.2.5 Penetration test for electrically conductive screen and/or sheath 8.2.6 Flammability test |
| 20 | 8.2.7 Deformation test for installation classification 8.2.7.1 General remark |
| 21 | 8.2.7.2 Class M1: cables intended for installation with low risk of mechanical damage 8.2.7.3 Class M2: cables intended for installation with higher risk of mechanical damage 8.2.8 Cold impact test |
| 22 | 8.2.9 Cold bend test |
| 23 | 8.2.10 Ageing test for insulation |
| 24 | 8.2.11 Ageing test for non-metallic sheath 8.2.12 Compatibility test 8.2.13 UV resistance test |
| 25 | 8.2.14 Tensile test |
| 26 | 8.2.15 Reverse winding test 8.2.16 Heat shock test |
| 27 | 8.2.17 There shall be no cracks in the outer layer visible by visual inspection, both from the outside and from the inside after removing the sheath..If the sample fails during the test, two new samples shall be tested and if both samples pass the tes… 8.2.18 Hot set test 8.2.19 Cyclic ageing test for the heating cable |
| 28 | 8.2.20 Cyclic ageing test for splices and end seals 8.2.21 Checking of the durability of markings 8.2.22 Pressure test at high temperature for insulation and sheath |
| 29 | 8.3 Routine and sample tests 8.3.1 General remark 8.3.2 Voltage test 8.3.3 Heating cable resistance and output verification 8.3.4 Insulation thickness 8.3.5 Sheath thickness |
| 30 | 8.3.6 Hot set test |
