BSI 20/30409196 DC:2020 Edition
$13.70
BS EN 62037-1. Passive RF and microwave devices, intermodulation level measurement – Part 1. General requirements and measuring methods
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 19 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | CONTENTS |
| 5 | FOREWORD |
| 7 | PASSIVE RF AND MICROWAVE DEVICES, INTERMODULATION LEVEL MEASUREMENT 1 Scope 2 Normative references 3 Abbreviations 4 Characteristics of intermodulation products |
| 8 | 5 Principle of test procedure 6 Test set-up 6.1 General 6.2 Test equipment 6.2.1 General |
| 9 | 6.2.2 Set-up 1 |
| 10 | 6.2.3 Set-up 2 7 Preparation of DUT and test equipment 7.1 General 7.2 Guidelines for minimizing generation of passive intermodulation |
| 11 | Table 1 – Guide for the design, selection of materials and handling of components that may be susceptive to PIM generation |
| 12 | Table 2 – Test set-up conditions 9.2 Example of results |
| 13 | 10 Measurement error |
| 14 | Figure 1 – Set-up 1; reverse IM-test set-up |
| 15 | Figure 2 – Set-up 2; forward IM-test set-up |
| 16 | Figure 3 – Passive intermodulation (PIM) measurement error caused by residual system error |
| 17 | A.2 Configuration of low-PIM terminations A.2.1 Long cable termination Figure A.1 – Long cable termination |
| 18 | Figure A.2 – Lumped termination with a linear attenuator |
| 19 | 1.1.1 B.1.1 Stepped frequency sweep method 1.1.2 B.1.2 Fixed frequency method B.2 Dynamic PIM testing B.3 Heating effects |
