BS ISO 1268-7:2001
$86.31
Fibre-reinforced plastics. Methods of producing test plates – Resin transfer moulding
| Published By | Publication Date | Number of Pages |
| BSI | 2001 | 12 |
This part of ISO 1268 specifies a method of preparing reinforced-plastic test plates by resin transfer moulding (RTM). It is intended to be read in conjunction with ISO 1268-1.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 3 | Fibre-reinforced plastics�— Methods of producing test plates�— |
| 5 | Contents Page |
| 6 | Foreword |
| 7 | Fibre-reinforced plastics�— Methods of producing test plates�— 1��� Scope 2��� Normative references 3��� Health and safety 4��� Principle |
| 8 | 5��� Materials 5.1��� Reinforcement 5.2��� Resin 6��� Plate dimensions 7��� Reinforcement content 8��� Apparatus 8.1��� Mould 8.2��� Press with heated platens 8.3��� Air-circulation oven 8.4��� Resin tanks 8.5��� Pump 8.6��� Vacuum pump |
| 9 | 8.7��� Flexible tubing 8.8��� Temperature and pressure control and recording equipment 9��� Procedure 9.1��� Preparation of preform 9.1.1��� Examples of methods of producing preforms 9.1.2��� The mass per surface area of the preform shall be such that the plates produced have the… 9.1.3��� The preform design shall be such that it matches the shape of the mould and correct alig… 9.2��� Resin injection and cure 9.2.1��� Depending on the nature of the resin and reinforcement, different procedures may be requ… 9.2.2��� Place the reinforcement in the cavity of the mould. Close the mould and clamp it shut wi… 9.2.3��� Place the reinforcement in the cavity of the mould, close the mould and clamp it shut. C… 9.2.4��� The injection-moulding process can also be used with highly reactive resins. Place the p… 9.2.5��� For all methods, record the temperature, pressure, duration under pressure and cure time. 9.3��� Stabilization |
| 10 | 10��� Verification of the characteristics of the plate obtained 10.1��� General 10.2��� Fibre content 10.3��� Void content 10.4��� Density 10.5��� Dimensions of the plate 10.6��� Degree of cure 10.7��� Fibre alignment 11��� Marking |
| 11 | 12��� Test plate preparation report |
