BS EN ISO 29864:2019
$102.76
Self adhesive tapes. Measurement of breaking strength and elongation at break
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 16 |
This document specifies methods to measure the breaking strength and elongation at break of a self adhesive tape when it is subjected to a tensile force sufficient to cause it to break. These test methods describe a procedure for testing 12 mm or 24 mm wide samples cut from supplied rolls of self adhesive tapes. Alternatively rolls of self adhesive tape up to 50 mm wide can be directly tested in their original width. In these circumstances the practical breaking strength and elongation will be typical of the manufacturer’s cut edges. When newly cut sample pieces are tested, because of the better cutting of the edges, the results can be higher than would be found on commercial tape.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 4 | European foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions 4 Significance and use |
| 10 | 5 Principle 6 Apparatus 6.1 Tensile testing machine 6.2 Clamps 6.3 Cylinders |
| 11 | 6.4 Scale 6.5 Cutting tool 7 Test sample and test pieces 8 Procedure 8.1 Testing conditions |
| 12 | 8.2 Preparation of test pieces 8.3 Method A for non-filament tapes 8.4 Method B for filament tapes 9 Expression of results 9.1 Expression of results for non-filament tapes |
| 13 | 9.2 Expression of results for filament tapes 10 Test report |
