BS EN ISO 13935-2:2014
$102.76
Textiles. Seam tensile properties of fabrics and made-up textile articles – Determination of maximum force to seam rupture using the grab method
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 20 |
This part of ISO 13935 specifies methods for the determination of seam maximum force of sewn seams when the force is applied perpendicularly to the seam. This part of ISO 13935 describes the method known as the grab test.
NOTE ISO 13935-1 describes the method known as the strip test. For informative references see the Bibliography.
The method is mainly applicable to woven textile fabrics, including fabrics which exhibit stretch characteristics imparted by the presence of an elastomeric fibre, mechanical or chemical treatment. It may be applicable to fabrics produced by other techniques. It is normally not applicable to geotextiles, nonwovens, coated fabrics, textile-glass woven fabrics and fabrics made from carbon fibres or polyolefin tape yarns (see Bibliography).
The sewn fabrics may be obtained from previously sewn articles or may be prepared from fabric samples, as agreed by the parties interested in the results.
This method is applicable to straight seams only and not to curved seams.
The method is restricted to the use of constant rate of extension (CRE) testing machines.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | Section sec_3.2 Section sec_3.3 Section sec_3.4 Section sec_4 Section sec_5 Section sec_6 Section sec_6.1 Section sec_6.1.1 Section sec_6.1.2 Section sec_6.1.3 4 Principle 5 Sampling 6 Apparatus |
| 11 | Section sec_6.1.4 Section sec_6.1.5 Section sec_6.1.6 Section sec_6.2 Section sec_6.3 Section sec_7 Section sec_8 Section sec_8.1 Section sec_8.2 7 Atmosphere for conditioning and testing 8 Preparation of seams and of test specimens 8.1 Preparation of seams, if required, before testing 8.2 Dimensions |
| 12 | Table tab_a Figure fig_1 Section sec_8.3 8.3 Preparation of test specimens |
| 13 | Table tab_b Figure fig_2 Section sec_9 Section sec_9.1 Section sec_9.2 Section sec_9.3 9 Procedure 9.1 Gauge length 9.2 Rate of extension 9.3 Mounting of test specimens |
| 14 | Section sec_9.4 Section sec_10 Section sec_11 9.4 Operation 10 Calculation and expression of results 11 Test report |
| 16 | Annex sec_A Table tab_c Figure fig_A.1 Annex A (informative) Arrangements of jaws for the grab test |
| 17 | Reference ref_1 Reference ref_2 Reference ref_3 Bibliography |
