BS EN 60695-11-2:2017
$142.49
Fire hazard testing – Test flames. 1 kW pre-mixed flame. Apparatus, confirmatory test arrangement and guidance
| Published By | Publication Date | Number of Pages |
| BSI | 2017 | 26 |
This part of IEC 60695 gives the requirements for the production and confirmation of a nominal 1 kW propane/air pre-mixed flame for use in fire hazard testing.
This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 [4] and ISO/IEC Guide 51 [5].
One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.
The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 5 | Annex ZA(normative)Normative references to international publicationswith their corresponding European publications |
| 7 | English CONTENTS |
| 8 | FOREWORD |
| 10 | INTRODUCTION |
| 11 | 1 Scope 2 Normative references 3 Terms and definitions |
| 12 | 4 Burner/supply arrangement 4.1 Requirements 4.2 Apparatus and fuel 4.2.1 Burner 4.2.2 Flow control |
| 13 | 4.2.3 Copper block 4.2.4 Thermocouple 4.2.5 Temperature/time indicating/recording devices 4.2.6 Laboratory fumehood/chamber 5 Production of the test flame 5.1 Selection of the method |
| 14 | 5.2 Method A 5.3 Method B (alternative) 6 Confirmation of the test flame 6.1 Principle 6.2 Frequency of confirmatory tests |
| 15 | 6.3 Procedure 7 Recommended arrangements for use of the test flame |
| 16 | Figures Figure 1 – Flame dimensions |
| 17 | Annex A (normative) Burner details, arrangements and confirmatory test A.1 Burner construction |
| 18 | Figure A.1 – General assembly Figure A.2 – Burner details (1) |
| 19 | Figure A.3 – Burner details (2) |
| 20 | Figure A.4 – Burner details (3) |
| 21 | Figure A.5 – Burner details (4) |
| 22 | A.2 Gas supply arrangement Figure A.6 – Example of supply arrangement for burner |
| 23 | A.3 The copper block A.4 Confirmatory test Figure A.7 – Copper block |
| 24 | Figure A.8 – Confirmatory test arrangement |
| 25 | Bibliography |
Related products
-
BS EN 60695-11-2:2017 – TC:2020 Edition
Tracked Changes. Fire hazard testing – Test flames. 1 kW pre-mixed flame. Apparatus, confirmatory test…
