BS EN 1914:2016 – TC:2020 Edition
$186.33
Tracked Changes. Inland navigation vessels. Work boats, ship’s boats and lifeboats
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 47 |
This European Standard applies to: – ship’s boats that shall be carried on inland navigation vessels according to Annex II of Directive 2006/87/EC; – lifeboats if no special life-saving equipment (e.g. ADN) is specified for the area of use; – work boats for the transport of a limited number of persons or smaller working loads in the construction site area and over comparatively short distances. This standard does not apply to: – recreational craft according to Directive 2013/53/EU; – firefighting and water rescue boats.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | compares BS EN 1914:2016 |
| 2 | TRACKED CHANGES Text example 1 — indicates added text (in green) |
| 29 | European Foreword |
| 30 | 1 Scope 2 Normative references 3 Terms and definitions |
| 31 | 4 Symbols |
| 32 | Table 1 — Symbols 5 Safety requirements 5.1 Dimensions |
| 33 | Figure 1 — Main dimensions 5.2 Freeboard 5.3 Boat volume 5.4 Reserve buoyancy AR 5.5 Stability |
| 34 | 5.6 Permissible number of persons 5.7 Drainage device 5.8 Buoyancy units 5.8.1 Hermetically-sealed buoyancy units 5.8.2 Buoyancy units filled with expanded materials 5.9 Non-slip surfaces |
| 35 | 5.10 Gunwale 5.11 Performance characteristics 5.11.1 General 5.11.2 Rowing 5.11.3 Additional requirements for boats with motor fitted 5.11.4 Recovery 5.12 Motor rating 5.12.1 Installation |
| 36 | 5.12.2 Maximum motor rating 5.12.3 Electric motors and starters 5.13 Towing ring, mooring and heating devices 5.14 Additional requirements for inflatable boats 6 Materials 7 Equipment 7.1 Basic equipment |
| 37 | 7.2 Additional equipment for boats with motor fitted |
| 38 | 7.3 Additional equipment for inflatable boats 7.4 Instructions for use 8 Testing 8.1 General 8.2 Verification of design data 8.3 Verification of reserve buoyancy 8.4 Verification of stability |
| 39 | 8.5 Practical test 8.6 Trial without motor fitted 8.7 Trial with motor fitted 8.7.1 Motor rating 8.7.2 Turning circle 8.7.3 Z-manoeuvre 8.7.4 Stopping test 8.7.5 Reversing |
| 40 | 8.8 Strength test 8.8.1 General 8.8.2 Drop test 8.8.3 Towing test 8.9 Recovery test 9 Designation 10 Marking |
| 41 | Table 2 — Required information on the manufacturer’s plate |
| 42 | Annex A (informative) Examples and preferred dimensions for a boat with rigid hull Figure A.1 — Example 1: Round-bottom boat Figure A.2 — Example 2: V-bottom boat |
| 43 | Table A.1 — Preferred dimensions for boats |
| 44 | Bibliography |
Related products
-
BS EN 61914:2016 – TC:2020 Edition
Tracked Changes. Cable cleats for electrical installations Published By Publication Date Number of Pages BSI…
