BS EN 15773:2018 – TC:2020 Edition
$186.33
Tracked Changes. Industrial application of powder organic coatings to hot dip galvanized or sherardized steel articles [duplex systems]. Specifications, recommendations and guidelines
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 53 |
This European Standard specifies the agreements to be made between the client, the galvanizer / sherardizer, the chemical suppliers and the applicators of the pre-treatment and the powder organic coating systems (if they are not one and the same). It also specifies the quality of the galvanized or sherardized articles to which the powder organic coatings are to be applied and for the pre-treatment and powder organic coatings intended for application to the galvanized or sherardized articles. This standard applies to the application of hot dip galvanized, sherardized and powder organic coatings by controlled industrial processes to articles consisting of or manufactured from steel. The standard applies to hot dip galvanized products, galvanized in accordance with EN ISO 1461 and EN 10240 or products sherardized in accordance with EN ISO 17668, as well as parts of these products manufactured from continuously galvanized sheet and strip galvanized in accordance with EN 10346, which, after the galvanizing and/or assembly, or sherardizing, will have a powder organic coating system applied. This standard also applies to products which have been hot dip galvanized or sherardized according to specific product standards to which powder organic systems are applied. This standard might also be useful when supplying other organic coating systems (excluding wet paint systems).
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 29 | National foreword |
| 31 | European foreword European foreword |
| 32 | Introduction |
| 34 | European foreword |
| 35 | Introduction |
| 36 | 1 Scope 2 Normative references |
| 37 | 3 Terms and definitions |
| 38 | 4 Ordering 4.1 General |
| 40 | 4.2 Request for quotation 4.3 Information provision |
| 41 | 4.4 Delivery of product prepared for coating 5 Fabrication 5.1 Surface condition of the steel 5.2 Nature and composition of the raw material 5.3 Welds, markings, labels 5.4 Deviations of edges and sides |
| 42 | 6 Zinc coating and zinc surface 6.1 Cooling 6.2 Quality and inspection of the zinc coating 6.3 Surface preparation prior to pre-treatment for application of powder organic coatings |
| 43 | 6.4 Storage, packaging and transport after galvanizing or sherardizing 6.5 Acceptance check 7 Pre-treatment of the zinc surface 7.1 General 7.2 Chemical pre-treatment 7.3 Mechanical pre-treatment (sweep blasting) |
| 44 | 8 Powder organic coating layers 8.1 General |
| 45 | 8.2 Specification of powder organic coating 8.3 Repair of the coating system 9 Packaging, storage and further movement of finished products 10 Installation 11 Inspection of finished products 12 Health and safety |
| 46 | Annex A (normative) Considerations when designing and fabricating items for galvanizing or sherardizing and subsequent application of powder organic coatings |
| 47 | Annex B (informative) Guidance on the influence of steel surface chemistry on the surface condition and pre-treatment of galvanized or sherardized articles prior to application of powder organic coatings |
| 49 | Annex C (informative) Guidance on treatment of hot dip galvanized or sherardized articles prior to pre-treatment for application of powder organic coatings |
| 50 | Annex D (informative) Guidance on pre-treatment of hot dip galvanized or sherardized articles prior to the application of powder organic coatings |
| 51 | Bibliography |
