ASTM-F467 2008(Redline)

$26.65

F467-08e1 Standard Specification for Nonferrous Nuts for General Use (Redline)

Published By	Publication Date	Number of Pages
ASTM	2008	17

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Abstract

This specification covers the chemical, mechanical, dimensional, and workmanship and finish requirements, and the corresponding test methods for commercial wrought nonferrous nuts in a variety of alloys in common use that are intended for general service applications. When tested, the nuts shall meet required values for hardness, proof stress, and tensile stress areas.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Significance and Use

For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29 .

1. Scope

1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications.

1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this specification are covered by Specification F468 .

1.3 This specification is the inch-pound companion to Specification F467M; therefore, no SI equivalents are presented in the specification.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B154 Test Method for Mercurous Nitrate Test for Copper Alloys B574 Specification for Low-Carbon Nickel-Chromium-Molybdenum, Low-Carbon Nickel-Molybdenum-Chromium, Low-Carbon Nickel-Molybdenum-Chromium-Tantalum, Low-Carbon Nickel-Chromium-Molybdenum-Copper, and Low-Carbon Nickel-Chromium-Molybdenum-Tungsten Alloy Rod D3951 Practice for Commercial Packaging E18 Test Methods for Rockwell Hardness of Metallic Materials E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications E34 Test Methods for Chemical Analysis of Aluminum and Aluminum-Base Alloys E38 Methods for Chemical Analysis of Nickel-Chromium and Nickel-Chromium-Iron Alloys E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes E55 Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods) E75 Test Methods for Chemical Analysis of Copper-Nickel and Copper-Nickel-Zinc Alloys E76 Test Methods for Chemical Analysis of Nickel-Copper Alloys E92 Test Method for Vickers Hardness of Metallic Materials E101 Test Method for Spectrographic Analysis of Aluminum and Aluminum Alloys by the Point-to-Plane Technique E120 Test Methods for Chemical Analysis of Titanium and Titanium Alloys E165 Practice for Liquid Penetrant Examination for General Industry E227 Test Method for Optical Emission Spectrometric Analysis of Aluminum and Aluminum Alloys by the Point-to-Plane Technique E354 Te