ASTM-F1667:2011 Edition

$63.38

F1667-11a Standard Specification for Driven Fasteners: Nails, Spikes, and Staples

Published By	Publication Date	Number of Pages
ASTM	2011	46

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F1667-11a

Historical Standard: Standard Specification for Driven Fasteners: Nails, Spikes, and Staples

ASTM F1667

Scope

1.1 This specification covers nails, spikes, staples, and other driven fasteners, as listed in Table 1.

Note 1—Fastener ductility information is presented in Table 2 and dimensional information in Tables 3-67.

1.2 Fasteners described in this specification are driven by hand tool, power tool, or mechanical device in single or multiple strikes and are positioned by hand, tool, or machine.

1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 Fasteners in this specification are sold in bulk (loose) form and are collated for loading into the magazine of an application tool. Other than as covered in Section 9, Workmanship, cohering materials (including, but not limited to, plastic, adhesive bond, paper tape, plastic strip, plastic carrier, wire, etc.) and relative orientation of collated fasteners are not within the scope of this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

diameter; driven fasteners; head; length; nails; point; spikes; staples

ICS Code

ICS Number Code n/a

DOI: 10.1520/F1667-11A

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Classification Ordering Information
2	Material Requirements Physical Properties TABLE 1 TABLE 2
3	Dimensions and Tolerances Workmanship Protective Coatings and Finishes
4	Certification Packaging and Package Marking Keywords
5	TABLE 3 TABLE 4
6	TABLE 5 TABLE 6
7	TABLE 7 TABLE 8
8	TABLE 9 TABLE 10
9	TABLE 11 TABLE 12
10	TABLE 13 TABLE 14
11	TABLE 15 TABLE 16
12	TABLE 17 TABLE 18
13	TABLE 19 TABLE 20
14	TABLE 21 TABLE 22
15	TABLE 23 TABLE 24
16	TABLE 25
17	TABLE 26 TABLE 27
18	TABLE 28
19	TABLE 29
20	TABLE 30 TABLE 31
21	TABLE 32
22	TABLE 33
23	TABLE 33
24	TABLE 34 TABLE 35
25	TABLE 36 TABLE 37
26	TABLE 38
27	TABLE 39 TABLE 40
28	TABLE 41 TABLE 42
29	TABLE 43 TABLE 44
30	TABLE 45
31	TABLE 46 TABLE 47
32	TABLE 48 TABLE 49
33	TABLE 50 TABLE 51
34	TABLE 52 TABLE 53
35	TABLE 54
36	TABLE 55
37	TABLE 56
38	TABLE 57 TABLE 58
39	TABLE 59
41	TABLE 60 TABLE 61
42	TABLE 62 TABLE 63
43	TABLE 64
44	TABLE 65
45	TABLE S1.1 TABLE S1.2