ASTM-E2486/E2486M 2018
$35.75
E2486/E2486M-13(2018) Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS)
| Published By | Publication Date | Number of Pages |
| ASTM | 2018 | 2 |
ASTM E2486/E2486M-13-Reapproved2018
Historical Standard: Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS)
ASTM E2486/E2486M
Scope
1.1 This test method covers a procedure for rapidly deforming by impact an EIFS for evaluating the effect of such deformation.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and to determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
EIFS; exterior insulation and finish systems; impact resistance;
ICS Code
ICS Number Code 19.020 (Test conditions and procedures in general)
DOI: 10.1520/E2486_E2486M-13R18
