ASTM-D7008 2008(Redline)

$23.40

D7008-08 Standard Specification for Geosynthetic Alternate Daily Covers (Redline)

Published By	Publication Date	Number of Pages
ASTM	2008	4

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Abstract

This specification covers the requirements for reusable and nonreusable geosynthetic alternate daily covers (ADCs) used on the working face of municipal solid waste landfills (MSWLF). Geosynthetic ADCs include a wide range of products including, but not limited to, reinforced film, unreinforced film, reinforced sheet, unreinforced sheet, coated geotextile and uncoated geotextile. Geosynthetic ADC are classified as nonreusable geosynthetic ADC, and reusable geosynthetic ADC. The breaking factor, tear resistance, and puncture strength of the nonreusable ADC shall be tested to meet the requirements prescribed. The grab strength, trapezoidal tear, and puncture resistance of the reusable ADC shall be tested to meet the requirements prescribed.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers the requirements for reusable and nonreusable geosynthetic alternate daily covers (ADCs) used on the working face of municipal solid waste landfills (MSWLF). Geosynthetic ADCs include a wide range of products including, but not limited to, reinforced film, unreinforced film, reinforced sheet, unreinforced sheet, coated geotextile and uncoated geotextile.

1.2 This standard addresses the base ADC materials and does not address grommets, straps or other fabricated parts.

1.3 The values stated in SI units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D882 Test Method for Tensile Properties of Thin Plastic Sheeting D1004 Test Method for Tear Resistance (Graves Tear) of Plastic

Additional information