ASTM-D6117:2018 Edition(Redline)

$36.83

D6117-18 Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes (Redline)

Published By	Publication Date	Number of Pages
ASTM	2018	11

Guaranteed Safe Checkout

Categories: 83.140.01 - Rubber and plastics products in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM D6117-18

Redline Standard: Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes

ASTM D6117

Scope

1.1 These test methods cover the evaluation of fastener use with “as manufactured” plastic lumber and shapes through the use of two different testing procedures.

1.2 The test methods appear in the following order:

1.3 Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, these test methods would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section.

1.4 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this standard.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

mechanical fasteners; plastic lumber; plastic shapes; recycled plastics;

ICS Code

ICS Number Code 83.140.01 (Rubber and plastic products in general)

DOI: 10.1520/D6117-18