ASTM-D5125:2020 Edition

$34.13

D5125-10(2020)e1 Standard Test Method for Viscosity of Paints and Related Materials by ISO Flow Cups

Published By	Publication Date	Number of Pages
ASTM	2020

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D5125-10-e1-Reapproved2020

Active Standard: Standard Test Method for Viscosity of Paints and Related Materials by ISO Flow Cups

ASTM D5125

Scope

1.1 This test method covers the determination of the flow time (viscosity) of Newtonian and near-Newtonian paints, and related coatings and products using ISO capillary flow cups.

Note 1: If the liquid is non-Newtonian, that is shear-thinning or thixotropic, Test Methods D2196 should be used.

1.2 The cup-orifice combination (ISO cup with orifice diameter of 3 mm, 4 mm, 5 mm, or 6 mm)2 is selected to provide an efflux time with the range of 20 to 100 s and viscosities up to 700 cSt (700 mm²/s). The most commonly used cup is the one with the 4-mm orifice.

1.3 This test method is limited to testing materials for which the breakpoint of the flow from the orifice of the flow cup can be determined with certainty. This point is difficult to determine and reproduce for materials with flow times in excess of 100 s due to slowing-down effects.

1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

Note 2: The International Civil Aviation Organization (ICAO) and the International Maritime Organization (IMO) include in their regulations a similar test (ISO 2431) to determine the viscosity of hazardous viscous liquids. The viscosity is then used to place these liquids in a hazard packaging group depending on their viscosity/flashpoint relationship. The U. S. Department of Transportation permits the use of these regulations for transhipment of hazardous material within the U.S. when bound for foreign destinations.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

efflux cups; flow cups; ISO cups; viscosity;

ICS Code

ICS Number Code 87.040 (Paints and varnishes)

DOI: 10.1520/D5125-10R20E01

Additional information

Standard Title	D5125-10(2020)e1 Standard Test Method for Viscosity of Paints and Related Materials by ISO Flow Cups
Published Code	ASTM
Publication Date	2020