ASTM-D4629 2008

$40.63

D4629-08 Standard Test Method for Trace Nitrogen in Liquid Petroleum Hydrocarbons by Syringe/Inlet Oxidative Combustion and Chemiluminescence Detection

Published By	Publication Date	Number of Pages
ASTM	2008	5

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D4629-08

Historical Standard: Standard Test Method for Trace Nitrogen in Liquid Petroleum Hydrocarbons by Syringe/Inlet Oxidative Combustion and Chemiluminescence Detection

ASTM D4629

Scope

1.1 This test method covers the determination of the trace total nitrogen naturally found in liquid hydrocarbons boiling in the range from approximately 50 to 400°C, with viscosities between approximately 0.2 and 10 cSt (mm²/s) at room temperature. This test method is applicable to naphthas, distillates, and oils containing 0.3 to 100 mg/kg total nitrogen. For liquid hydrocarbons containing more than 100 mg/kg total nitrogen, Test Method D 5762 can be more appropriate. This test method has been successfully applied, during interlaboratory studies, to sample types outside the range of the scope by dilution of the sample in an appropriate solvent to bring the total nitrogen concentration and viscosity to within the range covered by the test method. However, it is the responsibility of the analyst to verify the solubility of the sample in the solvent and that direct introduction of the diluted sample by syringe into the furnace does not cause low results due to pyrolysis of the sample or solvent in the syringe needle.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 6.2, 6.4, 6.5, 6.9, and Section 7.

Keywords

Boundary lubrication properties; Chemiluminescence detection; Combustion–petroleum products; Distillate fuels; Hydrocarbons; Naphtha and naphtha derivatives; Nitrogen content–petroleum products; Petroleum oils; Process feeds; Trace elements–petroleum products; Viscosity–petroleum products

ICS Code

ICS Number Code 75.080 (Petroleum products in general)

DOI: 10.1520/D4629-08

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Summary of Test Method Significance and Use
2	Apparatus Reagents
3	Hazards Sampling Assembly Apparatus Calibration and Standardization Procedure
4	Calculation Quality Assurance/Quality Control (QA/QC) Precision and Bias TABLE 1
5	X1. QUALITY CONTROL (QC) MONITORING X1.1 X1.2 X1.3 X1.4 X1.5 X1.6

Additional information

Standard Title	D4629-08 Standard Test Method for Trace Nitrogen in Liquid Petroleum Hydrocarbons by Syringe/Inlet Oxidative Combustion and Chemiluminescence Detection
Published Code	ASTM
Publication Date	2008
Pages Count	5