ASTM-B395 2008
$44.96
B395/B395M-08 Standard Specification for U-Bend Seamless Copper and Copper Alloy Heat Exchanger and Condenser Tubes
| Published By | Publication Date | Number of Pages |
| ASTM | 2008 | 12 |
1.1 This specification establishes the requirements for condenser, evaporator, and heat exchanger U-bend tubes that are manufactured from seamless copper and copper alloy tube.
1.2 The following safety hazard caveat pertains only to the test methods described in this specification.
1.2.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
1.3 Units The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This specification is applicable to product 2 in. [50 mm] or less, inclusive, in diameter.
1.5 The product shall be produced from one of the following coppers or copper alloys, as specified in the ordering information:
A Designations listed in Classification B 224 .
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents |
| 2 | Terminology Ordering Information Materials and Manufacture Chemical Composition |
| 3 | TABLE 1 |
| 4 | Temper Grain Size of Annealed Tempers Mechanical Property Requirements Performance Requirements TABLE 2 |
| 5 | Other Requirements TABLE 3 TABLE 4 |
| 6 | Dimensions, Mass, and Permissible Variations TABLE 5 TABLE 6 TABLE 7 TABLE 8 |
| 7 | TABLE 9 TABLE 10 TABLE 11 TABLE 12 |
| 8 | Workmanship, Finish, and Appearance Sampling FIG. 1 TABLE 13 TABLE 14 FIG. 2 TABLE 15 TABLE 16 |
| 9 | Number of Tests and Retests Specimen Preparation |
| 10 | Test Methods Significance of Numerical Limits Inspection Rejection and Rehearing Certification Mill Test Report Packaging and Package Marking |
| 11 | Keywords |
Related products
-
ASTM-B395 2008(Redline)
B395/B395M-08 Standard Specification for U-Bend Seamless Copper and Copper Alloy Heat Exchanger and Condenser Tubes…
