ASTM-A815:2008 Edition

$40.63

A815/A815M-08 Standard Specification for Wrought Ferritic, Ferritic/Austenitic, and Martensitic Stainless Steel Piping Fittings

Published By	Publication Date	Number of Pages
ASTM	2008	8

Guaranteed Safe Checkout

Categories: 23.040.40 - Metal fittings, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers two general classes, WP and CR, of wrought ferritic, ferritic/austenitic, and martensitic stainless steel fittings of seamless and welded construction covered by the latest revision of Specification A 960/A 960M . Fittings differing from these standards may be furnished in accordance with Supplementary Requirement S8.

1.1.1 Class WP fittings are subdivided into four subclasses: Classes WP-S, WP-W, WP-WX, and WP-WU. They are manufactured to the requirements of Specification A 960/A 960M , and they shall have pressure ratings compatible with 12.2. Class WP-S fittings are those manufactured from seamless product by a seamless method of manufacture (marked with class symbol WP-S); Class WP-W fittings are those which contain welds where the fitting fabrication or construction welds have been radiographed (marked with class symbol WP-W); and Class WP-WX fittings are those which contain welds where all welds have been radiographed (marked with class symbol WP-WX); and Class WP-WU fittings are those which contain welds where all welds have been ultrasonically tested (marked with class symbol WP-WU).

1.1.2 Class CR fittings are those manufactured to the requirements of MSS SP-43, and they shall have pressure ratings compatible with 12.3.

1.2 This specification does not apply to cast fittings.

1.3 Optional supplementary requirements are provided. When desired, one or more of these may be specified in the order.

1.4 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable M specification designation [SI units], the material shall be furnished to inch-pound units.

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Common Requirements and Ordering Information Materials TABLE 1
3	Manufacture Heat Treatment
4	Chemical Composition Tensile Requirements Hardness Requirements Dimensions TABLE 2
5	Workmanship, Finish, and Appearance TABLE 3 TABLE 4
6	Hydrostatic Tests Rejection Rehearing Test Reports Keywords

Additional information

Standard Title	A815/A815M-08 Standard Specification for Wrought Ferritic, Ferritic/Austenitic, and Martensitic Stainless Steel Piping Fittings
Published Code	ASTM
Publication Date	2008
Pages Count	8
ICS Codes	23.040.40 - Metal fittings

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-A815:2008 Edition

PDF Catalog

Related products