🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-A511/A511M:2015 Edition

ASTM-A511/A511M:2015 Edition

$44.96

A511/A511M-15 Standard Specification for Seamless Stainless Steel Mechanical Tubing

Published By Publication Date Number of Pages
ASTM 2015 12
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM A511/A511M-15

Historical Standard: Standard Specification for Seamless Stainless Steel Mechanical Tubing

ASTM A511/A511M

Scope

1.1 This specification covers seamless stainless tubing for use in mechanical applications where corrosion-resistant or high-temperature strength is needed. The grades covered are listed in Table 1, Table 2, and Table 3.

(A) For small diameter or thin wall tubing or both, where many drawing passes are required, a maximum of 0.040 % carbon is necessary in grades MT-304L and MT-316L. Small outside diameter tubes are defined as those under a 0.500 in. [12.7 mm] outside diameter and light-wall tubes as those under a 0.049 in. [1.2 mm] average wall thickness (0.044 in. [1.1 mm] min wall thickness).
(B) Iron shall be determined arithmetically by difference of 100 minus the sum of the other specified elements.
(C) The range of (Al + Ti) shall be within 0.85–1.20 %.

(A) MT446-2 is a lower carbon version of MT446-1, that has a lower tensile strength but improved ductility and toughness.
(B) Carbon plus nitrogen = 0.025 max %.

(A) Maximum, unless a range or minimum is indicated. Where ellipses (…) appear in this table, there is no requirement and analysis for the element need not be determined or reported.
(B) % Cr + 3.3 X % Mo + 16X % N ≥ 40.

1.2 This specification covers seamless cold-finished mechanical tubing and seamless hot-finished mechanical tubing in sizes up to 123/4 in. [325 mm] in outside nominal diameter (for round tubing) with wall thicknesses as required.

1.3 Tubes shall be furnished in one of the following shapes, as specified by the purchaser: round, square, rectangular, or special.

1.4 Optional supplementary requirements are provided and when desired, shall be stated in the order.

1.5 The values stated in inch-pound units are to be regarded as the standard. Within the text, the SI units are shown in square brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.

Keywords

austenitic stainless steel; duplex stainless steel; ferritic/austenitic stainless steel; mechanical tubing; seamless steel tube; stainless steel tube; steel tube ;

ICS Code

ICS Number Code 23.040.10 (Iron and steel pipes)

DOI: 10.1520/A0511_A0511M-15

Related products

ASTM-A511/A511M
$44.96