This part of ISO 10896 specifies safety requirements and means of verification for tilting operator\u2019s cabs of trucks covered by ISO 10896\u20111 and ISO 10896\u20112 , where the seat index point height (SIP) is lifted not more than 400 mm when the cab is fully tilted. See Figure 1.<\/p>\n
Figure 1<\/b> Tilting operator’s cab<\/p>\n
Dimension in millimetres<\/p>\n
Key<\/b><\/p>\n
This part of ISO 10896 only deals with significant hazards, hazardous situations or hazardous events relevant to the tilting cab affixed to trucks.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 2<\/td>\n | National foreword <\/td>\n<\/tr>\n | ||||||
| 6<\/td>\n | Foreword <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | Introduction <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | 1 Scope 2 Normative references <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | 3 Terms and definitions 4 Safety requirements and\/or protective measures 4.1 General 4.1.1 Access 4.1.2 Operator’s seat 4.1.3 Tilting operator’s cab <\/td>\n<\/tr>\n | ||||||
| 11<\/td>\n | 4.1.4 Travel restrictions 4.1.5 Maintenance 4.2 Tilting control 4.3 Stability 4.4 Crushing hazard 4.5 Roll over protective structure (ROPS) for tilting operator\u2019s cabs 4.6 Falling object protective structure (FOPS) 5 Verification of the safety requirements and\/or protective measures <\/td>\n<\/tr>\n | ||||||
| 12<\/td>\n | 6 Information for use <\/td>\n<\/tr>\n | ||||||
| 13<\/td>\n | Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Rough-terrain trucks. Safety requirements and verification – Tilting operator’s cabs<\/b><\/p>\n |